D-BT1A | WALL-MOUNTED BLUETOOTH AUDIO INPUT PLATE, MONO SUMMED OR STEREO AUDIO, FORMAT-A INTERFACE / WHITE

D-BT1A
WALL-MOUNTED BLUETOOTH AUDIO INPUT PLATE, MONO SUMMED OR STEREO AUDIO, FORMAT-A INTERFACE / WHITE

Welcome to BAI, your premier destination for professional and commercial electronics solutions. We are proud to offer a wide range of top-quality products, including the RDL Format-A products, RDL Brand.   

D-BT1A - Wall-Mounted Bluetooth^® Audio Format-A Interface Features

• Bluetooth Audio Input for Installed Sound System
• Intuitive Single Button Pairing with LED Status Indication
• Special Software Not Required for Module Setup
• Customize the Module ID Name and Programming Password through the Bluetooth Connection
• Sends Received Bluetooth Audio to RDL Format-A Receivers
• Mono Summed or Stereo Audio Input Mode is Switch-Selectable on Rear Panel
• Rear-Panel Switch Selects which RJ45 Pair (A, B or C) is Fed in Mono Summed Mode
• Daisy-Chain up to Three D SERIES-BT1A modules to One Format-A Receiver in Mono Mode
• Remotely Powered through Twisted Pair Cable
• Signal and Power Pair Pass-Through on RJ45 Jacks

Recommended Stereo Format-A receiver: TX-TPR2A  **To complete a Bluetooth setup using the D SERIES-BT1A Wall-Mounted Bluetooth® Audio Format-A Interface, at least one compatible Format-A receiver and its recommended power supply must be used.

The D SERIES-BT1A modules are Bluetooth audio receiving modules compatible with RDL® Format-A twisted pair receivers. When paired with a compatible Bluetooth enabled device, the module receives stereo audio from the Bluetooth source. The stereo signal is sent through two Format-A pairs to any RDL Format-A receiver. A stereo/mono switch set by the installer permits summed mono audio to be sent over one switch-selected pair to the Format-A receiver.

If set for stereo operation, an additional Format-A source (set to Pair A) may be daisy chained with the D SERIES-BT1A to a three-pair Format-A receiver. If set for mono operation, up to three D SERIES-BT1A modules may be daisy chained to a single three-pair Format-A receiver. Connections between Format-A modules and Format-A receivers use standard CATx cable with RJ45 connectors.

The D SERIES-BT1A modules are powered from the Format-A receiver. The installer can customize the module name and programming password through the Bluetooth connection using a smartphone, computer or tablet terminal program. These modules feature studio-quality circuits and analog filters to provide audio performance exceeding expectations from consumer interface technologies.